FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



2. REMOVE FRONT DOOR SCUFF PLATE

HINT:
Use the same procedures described for the LH side.



3. REMOVE FRONT DOOR OPENING TRIM COVER

HINT:
Use the same procedures described for the LH side.



4. REMOVE CONSOLE UPPER PANEL GARNISH FRONT


B111912

  1. Using a clip remover, detach the claws and remove the garnish.

    HINT:
    Tape the clip remover tip before use.



5. REMOVE FRONT ASH RECEPTACLE ASSEMBLY


B110191

  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



    B111908E01

  1. Using a screwdriver, detach the 9 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the ash receptacle and then disconnect the connector.



6. REMOVE INSTRUMENT PANEL FINISH PANEL END


B105637E06

  1. Remove the screw.

  1. Using a screwdriver, detach the 3 clips and 3 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the finish panel end.



7. REMOVE INSTRUMENT SIDE PANEL


B105643E01

  1. Using a screwdriver, detach the 2 claws and 4 clips, and remove the side panel.

    HINT:
    Tape the screwdriver tip before use.



8. REMOVE INSTRUMENT PANEL UNDER NO.2 COVER SUB-ASSEMBLY


B108847E01

  1. Using a screwdriver, detach the 4 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connector and clamp, and remove the under cover.



9. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    C107050

  1. Remove the 3 bolts and front passenger side knee airbag assembly.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.