FRONT AXLE HUB BOLT > REPLACEMENT

for Preparation Click here



1. REMOVE FRONT WHEEL


2. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY


    C113083

  1. Remove the 2 bolts, and disconnect the brake caliper assembly.

    NOTICE:
    Use a wire or an equivalent to keep the brake caliper from hanging down by the flexible hose.



3. REMOVE FRONT DISC


    F041543E03

  1. Put matchmarks on the front disc and the axle hub.

  1. Remove the front disc.



4. REMOVE FRONT AXLE HUB BOLT


    C104833E01

  1. Using SST, remove the front axle hub bolt.

    SST
    09628-10011  

    NOTICE:
    Do not damage the threads of the hub bolts.



5. INSTALL FRONT AXLE HUB BOLT


    C101193E01

  1. Install a washer and nut to a new bolt as shown in the illustration.

  1. Using a screwdriver or an equivalent to hold the hub, turn the wheel nut to pull the hub bolt until the bottom surface of the hub bolt head touches the axle hub.

    NOTICE:
    Do not damage the threads of the hub bolts.



6. INSTALL FRONT DISC


    F041543E05

  1. Align the matchmarks, and install the front disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the front disc has the minimum runout.



7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY


    C113083

  1. Install the brake caliper assembly to the steering knuckle with the 2 bolts.

    Torque:
    78 N*m{ 795 kgf*cm , 58 ft.*lbf }

    NOTICE:
    1. Do not twist the front brake hose when installing the front disc brake caliper.
    2. Make sure that there are no foreign objects or damage to the threads of the bolts.
    3. Do not overtighten the bolts because the steering knuckle is made of aluminum and may be damaged.



8. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }