DTC    01-D6    No Master (G/W)

DTC    01-D7    Connection Check Error (G/W)

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
01-D6
*1
When either of following conditions is met:
  1. Device that stores (stored) the code has (had) been disconnected when engine switch is (was) on (ACC) or on (IG)
  2. The master device has (had) been disconnected when this code is (was) stored
  1. Wire harness
  2. Gateway ECU
  3. Multi-display
1-D7
*2
When either of following conditions is met:
  1. Device that stored this code has (had) been disconnected after engine starts (started)
  2. Master device has (had) been disconnected when this code is (was) stored

HINT:
  1. *1: Even if no failure is detected, a trouble code may be recorded depending on the battery condition or engine start voltage.
  2. When 210 seconds have elapsed after disconnecting the power supply connector of the master component with the engine switch on (ACC or IG), this code is stored.


INSPECTION PROCEDURE

1.CHECK MULTI-DISPLAY POWER SOURCE CIRCUIT
Refer to the "multi-display power source circuit" (Click here).
If the power source circuit is operating normally, proceed to the next step.

NEXT


2.CHECK AVC-LAN CIRCUIT BETWEEN RADIO RECEIVER ASSEMBLY AND GATEWAY ECU
Refer to the "AVC-LAN circuit between radio receiver assembly and gateway ECU" (Click here).
If the AVC-LAN circuit is operating normally, proceed to the next step.

NEXT


3.REPLACE GATEWAY ECU

  1. Replace the gateway ECU with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE MULTI-DISPLAY
OK

END