FRONT SEAT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
Use the same procedures for the LH and RH side.



1. INSTALL FRONT SEAT ASSEMBLY


B105963E02

  1. Place the seat in the cabin.

  1. Connect the connectors under the seat.

  1. Connect the cable to the negative (-) battery terminal.

  1. Operate the power seat switch knob and move the seat to the foremost position.

  1. Tighten the 2 bolts on the rear side of the seat.

    Torque:
    36.8 N*m{ 375 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the 2 bolts in the order indicated in the illustration.

  1. Operate the power seat switch knob and move the seat to the rearmost position.

  1. Tighten the 2 bolts on the rear side of the seat.

    Torque:
    36.8 N*m{ 375 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the 2 bolts in the order indicated in the illustration.



2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


B105919

  1. Move the seat using the power seat switch knob so that the seat belt anchor bolt is revealed.

  1. Install the front seat outer belt anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Install the seat belt anchor cover cap.

  1. Install the front seat belt hole cover.



3. PERFORM INITIALIZATION
Perform initialization (Click here).

CAUTION:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



4. CHECK SRS WARNING LIGHT
Check the SRS warning light (Click here).


5. INSPECT FRONT SEAT ASSEMBLY

  1. Check the power seat operation.

  1. Check the seat heater operation (with seat heater).

    1. Turn the engine switch on (IG).

    2. Turn the seat heater switch ON.

    3. Wait 5 minutes or more and confirm that the seat surface becomes warm.