DTC    01-DD    Master Reset (AUDIO H/U)

DTC    01-DF    Master Error (AUDIO H/U)

DTC    01-E1    Voice Processing Device ON Error (AUDIO H/U)

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
01-DD
*1
When the device that should be master has been disconnected after engine starts
  1. Wire harness
  2. Radio receiver assembly
  3. Stereo component amplifier
01-DF
*2
When device with display failure occurs, this code is stored
01-E1
*3
When stereo component amplifier device records that stereo component amplifier output does not function even while source device operates

HINT:
  1. *1: This code may be stored if the engine is started, turned off, and started again.
  2. *2: This code may be stored if the engine is started, idled for 60 seconds, turned off, and then started again.
  3. *3: Even if no failure is detected, a trouble code may be recorded depending on the battery condition or engine start voltage.


INSPECTION PROCEDURE

1.CHECK POWER SOURCE CIRCUIT (RADIO RECEIVER ASSEMBLY)
Please follow this page (Click here).
If the power source circuit is operating normally, proceed to the next step.

NEXT


2.CHECK AVC-LAN CIRCUIT (STEREO COMPONENT AMPLIFIER - RADIO RECEIVER ASSEMBLY)
Please follow this page (Click here).
If the AVC-LAN circuit is operating normally, proceed to the next step.

NEXT


3.CHECK RADIO RECEIVER ASSEMBLY

  1. Check that the malfunction disappears when the radio receiver assembly is replaced with a normal one.

    OK:
    Malfunction disappears.



OK
REPLACE RADIO RECEIVER ASSEMBLY
NG

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE