REAR SPEAKER > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  1. The procedures listed below are for the LH side.



1. INSTALL REAR SPEAKER ASSEMBLY


    E107377E01

  1. Temporarily install the speaker by attaching the claws of the speaker to the door panel.

  1. Install the speaker with the 3 screws.

    HINT:
    1. Install the screws in the order shown in the illustration.
    1. Do not touch the cone part of the speaker.

  1. Connect the connector.



2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


B110182

  1. Connect the 2 cables to the inside handle.



    B107096E04

  1. Install the weathrstrip to the trim by attaching the 4 clips labeled A.

  1. Attach the 4 clips labeled B and 2 new clips labeled C to install the trim together with the weatherstrip.

  1. Install the 2 screws.



    B109741E01

  1. Attach the 2 claws to install the trim lower cover.



3. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH


B106665E04

  1. Attach the 3 claws to install the bezel plug.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.