FRONT NO. 2 SPEAKER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  1. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


    B105662E05

  1. Using a screwdriver, detach the 2 clips and 2 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the speaker panel.



3. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY



E107380E01

  1. Remove the 2 bolts.

  1. Disconnect the connector and remove the speaker.

    HINT:
    Do not touch the cone part of the speaker.