REAR NO. 2 SPEAKER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  1. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH


B106665E03

  1. Using a screwdriver, detach the 3 claws and remove the bezel plug.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


B109741E02

  1. Detach the 2 claws and trim lower cover.



    B107096E01

  1. Remove the 2 screws.

  1. Detach the 6 clips labeled B, and remove the trim together with the weatherstrip.

  1. Detach the 4 clips labeled A to separate the weatherstrip.



    B110164

  1. Disconnect the 2 cables from the inside handle.

  1. Disconnect the connectors and remove the trim board.



4. REMOVE REAR NO. 2 SPEAKER ASSEMBLY


E107383

  1. Disconnect the connector.

  1. Remove the 2 screws and speaker.

    HINT:
    Do not touch the cone part of the speaker.