STEREO COMPONENT SPEAKER > INSPECTION

for Preparation Click here



1. INSPECT STEREO COMPONENT SPEAKER ASSEMBLY

  1. With the speaker installed, check that there is no looseness or other abnormalities.

  1. Check that there is no foreign matter in the speaker, no tears on the speaker's cone part, or other abnormalities.



    E072213E01

  1. Measure the resistance of the speaker.

    Standard resistance (Standard models):
    Tester Connection
    		Specified Condition
    4 (WF1+) - 3 (WF1-)
    		2.5 Ω
    2 (WF2+) - 1 (WF2-)
    		2.5 Ω

    Standard resistance (Mark Levinson models):
    Tester Connection
    		Specified Condition
    4 (WF1+) - 3 (WF2-)
    		14 Ω

    If the result is not as specified, replace the speaker assembly.