STEREO COMPONENT SPEAKER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE REAR SEAT CUSHION ASSEMBLY


B105946E01

  1. Detach the seat cushion's 2 front hooks from the vehicle body.

    NOTICE:
    Follow the instructions below carefully as the cushion frame deforms easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat for the other hook.

  1. Detach the seat cushion's 2 rear hooks from the seatback.

  1. Remove the seat cushion.



3. REMOVE REAR SEAT HEADREST ASSEMBLY LH AND RH


4. REMOVE REAR SEAT HEADREST ASSEMBLY CENTER


5. REMOVE REAR SEATBACK ASSEMBLY



B105947

  1. Using a screwdriver, detach the claws and remove the 2 rear seat covers.

    HINT:
    Tape the screwdriver tip before use.



    B105996E01

  1. Using a screwdriver, detach the claw to open the cap of the 3 rear seat shoulder belt guides.

  1. Remove the bolt and floor anchor part.



    B105948

  1. Remove the 4 bolts and 2 nuts.

  1. Remove the seatback.



6. REMOVE REAR SEAT OUTER BELT ASSEMBLY


    B107409

  1. Remove the bolt and anchor part of the rear seat outer belt assembly.



7. REMOVE REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH


B107410E02

  1. Disconnect the connector labeled A.

  1. Remove the bolt and the anchor part of the rear seat inner with center belt assembly RH labeled B.



8. REMOVE REAR DOOR SCUFF PLATE LH


B111627E01

  1. Using a moulding remover, detach the 5 claws and remove the scuff plate.



9. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.



10. REMOVE REAR SEAT SIDE GARNISH LH


B111632

  1. Using a moulding remover, pull the garnish in the direction indicated by the arrow in the illustration to detach the 5 claws. Then remove the garnish.



11. REMOVE REAR SEAT SIDE GARNISH RH

HINT:
Use the same procedures described for the LH side.



12. REMOVE ROOF SIDE GARNISH INNER LH


B111633

  1. Detach the 4 clips.

  1. Pull the garnish in the direction indicated by the arrow in the illustration to detach the 2 claws. Then remove the garnish.



13. REMOVE ROOF SIDE GARNISH INNER RH

HINT:
Use the same procedures described for the LH side.



14. REMOVE HIGH MOUNTED STOP LIGHT ASSEMBLY

  1. Remove the high mounted stop light.



15. REMOVE AUTOMATIC LIGHT CONTROL SENSOR

  1. Disconnect the connector and remove the sensor.



16. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY


B107409E08

  1. Remove the bolt and anchor of the rear seat outer belt.



    B107410E07

  1. Disconnect the connector labeled A.

  1. Remove the bolt labeled B and seat belt.



    B111292E01

  1. Using a moulding remover, detach the 4 claws and remove the belt guide LH.

    HINT:
    Use the same procedure described for the RH side.



    B111293E03

  1. Using a moulding remover, detach the 4 claws and remove the belt guide center.



    B112274

  1. Detach the clip and remove the panel.



17. REMOVE NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)


B111649

  1. Detach the 5 claws and 3 clips.

  1. Disconnect the connector and remove the panel.



18. REMOVE STEREO COMPONENT SPEAKER ASSEMBLY


    E107385

  1. Disconnect the connector.

  1. Remove the 4 bolts and speaker.

    HINT:
    Do not touch the cone part of the speaker.