FRONT STEREO COMPONENT SPEAKER > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL FRONT STEREO COMPONENT SPEAKER ASSEMBLY

  1. Connect the connector.



    E107389

  1. Temporarily install the speaker by aligning the positioning pins of the speaker to the instrument panel.

  1. Install the speaker with the 2 bolts.

    HINT:
    Do not touch the cone part of the speaker.



2. INSTALL SPEAKER HOLE COVER


    B105661E05

  1. Attach the 4 clips to install the hole cover.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.