STEERING PAD SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STEERING PAD SWITCH LH



E107598E01

  1. Measure the resistance of the switch connector.

    HINT:
    Before the inspection, check that the steering pad switch cable is not malfunctioning.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A-6 (AU1) - A-8 (EAU)
    Not pushed
    10 kΩ or higher
    A-6 (AU1) - A-8 (EAU)
    Pushed (SEEK+)
    Below 1 Ω
    A-6 (AU1) - A-8 (EAU)
    Pushed (SEEK-)
    0.3 kΩ
    A-6 (AU1) - A-8 (EAU)
    Pushed (VOL+)
    1 kΩ
    A-6 (AU1) - A-8 (EAU)
    Pushed (VOL-)
    3.2 kΩ
    A-7 (AU2) - A-8 (EAU)
    Not pushed
    10 kΩ or higher
    A-7 (AU2) - A-8 (EAU)
    Pushed (MODE)
    Below 1 Ω
    A-1 (IL+2) - A-8 (EAU)
    Always
    Below 1 Ω
    A-1 (IL+2) - B-1 (IL+2)
    Always
    Below 1 Ω
    A-7 (AU2) - B-4 (AU2)
    Always
    Below 1 Ω
    A-8 (EAU) - B-2 (EAU)
    Always
    Below 1 Ω
    A-8 (EAU) - B-3 (EAU)
    Always
    Below 1 Ω

    If the result is not as specified, replace the switch.



2. INSPECT STEERING PAD SWITCH RH



E107599E01

  1. Measure the resistance of the cable connector.

    HINT:
    Before the inspection, check that the steering pad switch cable is not malfunctioning.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 (AU2) - 2 (EAU)
    Not pushed
    10 kΩ or higher
    4 (AU2) - 3 (EAU)
    Not pushed
    10 kΩ or higher
    4 (AU2) - 2 (EAU)
    Pushed (ON HOOK)
    0.3 kΩ
    4 (AU2) - 3 (EAU)
    Pushed (ON HOOK)
    0.3 kΩ
    4 (AU2) - 2 (EAU)
    Pushed (OFF HOOK)
    1 kΩ
    4 (AU2) - 3 (EAU)
    Pushed (OFF HOOK)
    1 kΩ
    4 (AU2) - 2 (EAU)
    Pushed (VOICE)
    3.2 kΩ
    4 (AU2) - 3 (EAU)
    Pushed (VOICE)
    3.2 kΩ
    4 (AU2) - 2 (EAU)
    Always
    Below 1 Ω
    4 (AU2) - 3 (EAU)
    Always
    Below 1 Ω

    If the result is not as specified, replace the switch.