INJECTOR DRIVER > INSTALLATION

for Preparation Click here



1. INSTALL INJECTOR DRIVER


A105899

NOTICE:
  1. Be careful not to drop or strike the injector driver.
  2. The injector driver is grounded at the bolt and nut. To ensure that it is grounded, clean all oil and foreign matter from the installation areas of the injector driver and engine before installing the injector driver.

  1. Install the injector driver with the bolt and 2 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. INSTALL NO.1 ENGINE COVER


A105311

  1. Install the cover with the 3 clips.

  1. Connect the 4 connectors.

    NOTICE:
    Clip the connector securely.



3. INSTALL AIR CLEANER INLET


A107673

  1. Install the air cleaner inlet with the bolt.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



4. INSTALL COOL AIR INTAKE DUCT SEAL


A105932E01

  1. Install the intake duct seal with the 7 clips.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.