FUEL PUMP RESISTOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PUMP RESISTOR


A111525

  1. Install the fuel pump resistor and ground wire with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector with the clamp.



2. INSTALL ENGINE ROOM SIDE COVER RH


A105933E01

  1. Install the side cover with the 2 clips and nut.



3. INSTALL COOL AIR INTAKE DUCT SEAL


A105932E01

  1. Install the intake duct seal with the 7 clips.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.