FUEL PUMP RESISTOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE COOL AIR INTAKE DUCT SEAL


A109857E02

  1. Remove the 7 clips and intake duct seal.



3. REMOVE ENGINE ROOM SIDE COVER RH


A109858E02

  1. Remove the nut, 2 clips and side cover.



4. REMOVE FUEL PUMP RESISTOR


A107571

  1. Disconnect the connector and clamp from the fuel pump resistor.

  1. Remove the 3 bolts and fuel pump resistor, and disconnect the ground wire.