MULTI-DISPLAY > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL NO. 2 RADIO BRACKET


    E107372

  1. Install the bracket with the 5 bolts.



2. INSTALL NO. 1 RADIO BRACKET


    E107373

  1. Install the bracket with the 5 bolts.



3. INSTALL MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY

  1. Connect the connectors.



    E107980

  1. Insert the multi-display with radio receiver and attach the 2 clips on its backside.



    E107370

  1. Install the multi-display with radio receiver with the 4 bolts.



4. INSTALL INSTRUMENT PANEL FINISH PANEL END LH


B105636E10

  1. Attach the 4 clips and 3 claws to install the finish panel end.

  1. Install the screw.



5. INSTALL INSTRUMENT PANEL FINISH PANEL END RH


B105637E08

  1. Attach the 3 clips and 3 claws to install the finish panel end.

  1. Install the screw.



6. INSTALL CONSOLE UPPER PANEL ASSEMBLY


B111908E02

  1. Connect the connector.

  1. Attach the 9 clips to install the ash receptacle.



    B110192

  1. Install the shift lever knob and twist it in the direction indicated by the arrow.



7. INSTALL FRONT CONSOLE UPPER PANEL GARNISH

  1. Attach the claws to install the garnish.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


9. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.