NAVIGATION ECU > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH


B111912

  1. Using a clip remover, detach the claws and remove the garnish.

    HINT:
    Tape the clip remover tip before use.



3. REMOVE CONSOLE UPPER PANEL ASSEMBLY


B110191

  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



    B111908E01

  1. Using a screwdriver, detach the 9 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the ash receptacle and then disconnect the connector.



4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH


B105637E06

  1. Remove the screw.

  1. Using a screwdriver, detach the 3 clips and 3 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the finish panel end.



5. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.



6. REMOVE FRONT DOOR OPENING TRIM COVER RH

HINT:
Use the same procedures described for the LH side.



7. REMOVE INSTRUMENT SIDE PANEL RH


B105643E01

  1. Using a screwdriver, detach the 2 claws and 4 clips, and remove the side panel.

    HINT:
    Tape the screwdriver tip before use.



8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B108847E01

  1. Using a screwdriver, detach the 4 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connector and clamp, and remove the under cover.



9. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    C107050

  1. Remove the 3 bolts and front passenger side knee airbag assembly.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



10. REMOVE GLOVE COMPARTMENT DOOR SUB-ASSEMBLY


B105648E01

  1. Remove the 4 screws.

  1. Detach the 2 clips and claw.

  1. Disconnect the connector and clamp.

  1. Remove the glove compartment door.



11. REMOVE NAVIGATION ECU WITH DISC PLAYER BRACKET

  1. Disconnect the connectors.



    B108094

  1. Remove the 3 bolts and navigation ECU.



12. REMOVE NO. 2 DISC PLAYER BRACKET


    E108525

  1. Remove the 2 screws and bracket.



13. REMOVE NO. 1 DISC PLAYER BRACKET


    E108524

  1. Remove the 2 screws and bracket.



14. REMOVE NAVIGATION ECU