WIPER SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 3. REMOVE NO. 3 STEERING WHEEL COVER LOWER |
![]() |
Using a screwdriver, remove the steering wheel No.3 cover lower.
| 4. REMOVE NO. 2 STEERING WHEEL COVER LOWER |
![]() |
Using a screwdriver, remove the steering wheel No.2 cover lower.
| 5. REMOVE STEERING PAD |
![]() |
Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.
![]() |
Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
Disconnect the horn connector.
Disconnect the 2 connectors and remove the steering pad.
| 6. REMOVE STEERING WHEEL ASSEMBLY |
| 7. REMOVE STEERING COLUMN COVER |
| 8. REMOVE SPIRAL CABLE WITH STEERING SENSOR |
![]() |
Disconnect the connectors from the spiral cable with steering sensor.
Disengage the 3 claws and remove the spiral cable with steering sensor.
| 9. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY |
![]() |
Disconnect the connector.
Detach the claw and remove the wiper switch.