FRONT WASHER MOTOR > INSTALLATION

for Preparation Click here



1. INSTALL HEADLIGHT CLEANER CONTROL RELAY (w/ Headlight Cleaner System)


2. INSTALL HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY (w/ Headlight Cleaner System)


3. INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


4. INSTALL WINDSHIELD WASHER JAR AND PUMP ASSEMBLY


    B109713

  1. Install the windshield washer jar and pump with the 3 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



    B107390

  1. Install the upper part of the washer jar and pump to the windshield washer jar and pump.

  1. Install the upper part of the washer jar and pump with the bolt.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



    B107386

  1. w/ Headlight cleaner system:
    Connect the headlight cleaner hose to the windshield washer jar and pump.

  1. w/o Headlight cleaner system:
    Connect the 2 connectors.

  1. w/ Headlight cleaner system:
    Connect the 4 connectors.



5. FILL WINDSHIELD WASHER JAR AND PUMP ASSEMBLY WITH WASHER FLUID


B107388

  1. Connect the washer hose to the windshield washer motor and pump, and fill the washer jar with washer fluid.



6. INSTALL HEADLIGHT ASSEMBLY LH


B109717E02

  1. Attach the claw and install the headlight with the 3 screws.

  1. w/ Headlight cleaner:
    Connect the hose.



    B110740

  1. Connect the connector as shown in the illustration.



7. INSTALL NO. 3 COOL AIR INTAKE DUCT SUB-ASSEMBLY


B109137

  1. Install the duct with the 3 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



8. INSTALL FRONT BUMPER COVER

  1. Connect the ultrasonic sensor connector.



    B107496E02

  1. Attach the 3 claws on the LH side.

  1. Attach the 3 claws on the RH side.



    B109982

  1. Install the bumper cover with the 2 clips, 6 screws and 5 bolts.



9. INSTALL FRONT FENDER LINER LH


B109136E03

  1. Install the front liner with the 2 bolts and clip.



10. INSTALL FRONT FENDER LINER RH


B110691E01

  1. Install the fender liner with the 2 clips.



11. INSTALL ENGINE UNDER COVER


B107493

  1. Install the under cover with the 3 clips and 10 screws.



12. INSTALL COOL AIR INTAKE DUCT SEAL


A105932E01

  1. Install the intake duct seal with the 7 clips.



13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


14. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.