FRONT WASHER MOTOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE COOL AIR INTAKE DUCT SEAL


A105932E01

  1. Remove the 7 clips and duct seal.



3. REMOVE ENGINE UNDER COVER


B107493

  1. Using a clip remover, remove the 3 clips.

  1. Remove the 10 screws and under cover.



4. REMOVE FRONT FENDER LINER LH


B109136E03

  1. Using a screwdriver, remove the 2 clips.

  1. Remove the 2 bolts and partially remove the fender liner.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover, windshield washer jar and pump can be removed in a later step.



5. REMOVE FRONT FENDER LINER RH


    B110691E01

  1. Using a screwdriver, remove the 2 clips and partially remove the fender liner.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed in a later step.



6. REMOVE FRONT BUMPER COVER

  1. Using a clip remover, remove the 2 clips.

    HINT:
    Put protective tape under the front fender.



    B109982

  1. Remove the 6 screws and 5 bolts.



    B106150E01

  1. Pull the bumper cover to detach the 3 claws on the LH side.

  1. Pull the bumper cover to detach the 3 claws on the RH side and remove the bumper cover.

  1. w/ Clearance sonar system:
    Disconnect the ultrasonic sensor connector.



7. REMOVE NO. 3 COOL AIR INTAKE DUCT SUB-ASSEMBLY


B109137

  1. Remove the 3 bolts and duct.



8. REMOVE HEADLIGHT ASSEMBLY LH


B109718

  1. Disconnect the connector as shown in the illustration.



    B109717E01

  1. Remove the 3 bolts.

  1. w/ Headlight cleaner:
    Disconnect the headlight cleaner hose.

  1. Detach the claw and remove the headlight.



9. DRAIN WASHER FLUID


B107387

  1. Remove the washer hose from the windshield washer motor and pump, and drain the washer fluid.



10. REMOVE WINDSHIELD WASHER JAR AND PUMP ASSEMBLY

  1. w/o Headlight cleaner system:
    Disconnect the 2 connectors.

  1. w/ Headlight cleaner system:
    Disconnect the 4 connectors.



    B107385

  1. w/ Headlight cleaner system:
    Loosen the clip and disconnect the headlight cleaner hose.



    B107389E02

  1. Remove the bolt.

  1. Pull the upper part of the washer jar and pump upward. Then remove it from the windshield washer jar and pump.



    B109713

  1. Remove the 3 bolts. Then remove the windshield washer jar and pump.



11. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


12. REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY (w/ Headlight Cleaner System)


13. REMOVE HEADLIGHT CLEANER CONTROL RELAY (w/ Headlight Cleaner System)