HEADLIGHT WASHER ACTUATOR > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for both the RH and LH sides.
  1. The procedures listed below are for the LH side.



1. INSTALL HEADLIGHT CLEANER HOSE


    B107516E02

  1. Attach the 5 clamps and install the hose to the front bumper reinforcement.

  1. Connect the hose to the headlight cleaner motor and pump.



2. INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY


B107517

  1. Install the headlight washer actuator to the headlight with the 2 screws.



3. INSTALL HEADLIGHT ASSEMBLY


B109717E02

  1. Attach the claw and install the headlight with the 3 screws.

  1. w/ Headlight cleaner:
    Connect the hose.



    B110740

  1. Connect the connector as shown in the illustration.



4. INSTALL FRONT BUMPER COVER

  1. Connect the ultrasonic sensor connector.



    B107496E02

  1. Attach the 3 claws on the LH side.

  1. Attach the 3 claws on the RH side.



    B109982

  1. Install the bumper cover with the 2 clips, 6 screws and 5 bolts.



5. INSTALL FRONT FENDER LINER LH


    B106148

  1. Install the fender liner with the 2 clips.



6. INSTALL FRONT FENDER LINER RH

HINT:
Use the same procedures described for the LH side.



7. INSTALL ENGINE UNDER COVER


B107493

  1. Install the under cover with the 3 clips and 10 screws.



8. INSTALL COOL AIR INTAKE DUCT SEAL


A105932E01

  1. Install the intake duct seal with the 7 clips.



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


10. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.