HEADLIGHT WASHER ACTUATOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for both the RH and LH sides.
  1. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE COOL AIR INTAKE DUCT SEAL


A105932E01

  1. Remove the 7 clips and duct seal.



3. REMOVE ENGINE UNDER COVER


B107493

  1. Using a clip remover, remove the 3 clips.

  1. Remove the 10 screws and under cover.



4. REMOVE FRONT FENDER LINER LH


B106148

  1. Using a screwdriver, remove the 2 clips.

  1. Partially remove the fender liner.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the bumper assembly can be removed later.



5. REMOVE FRONT FENDER LINER RH

HINT:
Use the same procedures described for the LH side.



6. REMOVE FRONT BUMPER COVER

  1. Using a clip remover, remove the 2 clips.

    HINT:
    Put protective tape under the front fender.



    B109982

  1. Remove the 6 screws and 5 bolts.



    B106150E01

  1. Pull the bumper cover to detach the 3 claws on the LH side.

  1. Pull the bumper cover to detach the 3 claws on the RH side and remove the bumper cover.

  1. w/ Clearance sonar system:
    Disconnect the ultrasonic sensor connector.



7. REMOVE HEADLIGHT ASSEMBLY


B109718

  1. Disconnect the connector as shown in the illustration.



    B109717E01

  1. Remove the 3 bolts.

  1. w/ Headlight cleaner:
    Disconnect the headlight cleaner hose.

  1. Detach the claw and remove the headlight.



8. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY


B107517

  1. Remove the 2 screws and headlight washer actuator.



9. REMOVE HEADLIGHT CLEANER HOSE

  1. Disconnect the hose from the headlight cleaner motor and pump.



    B107516E02

  1. Using a screwdriver, detach the 5 clamps and remove the hose.

    HINT:
    Tape the screwdriver tip before use.