CRUISE CONTROL MAIN SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL CRUISE CONTROL MAIN SWITCH


B107521E02

  1. Install the switch with the 2 screws.

    Torque:
    1.7 to 3.0 N*m{ 17 to 31 kgf*cm , 15 to 27 in.*lbf }

  1. Connect the connector.



2. INSTALL STEERING WHEEL ASSEMBLY
For 3GR-FE (Click here)
For 3GR-FSE (Click here)
For 3UZ-FE (Click here)


3. INSTALL STEERING WHEEL PAD


    C106868

  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 connectors to the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Connect the horn connector.



    C108774

  1. Confirm that the circumference groove of the "torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

  1. Using a "torx" socket wrench (T30), tighten the 2 "torx" screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



4. INSTALL NO. 3 STEERING WHEEL COVER LOWER


5. INSTALL NO. 2 STEERING WHEEL COVER LOWER


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. PERFORM INITIALIZATION

CAUTION:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

  1. Perform initialization (Click here).



8. CHECK SRS WARNING LIGHT

  1. Check the SRS warning light (Click here).