CLEARANCE WARNING ECU (for RHD) > INSTALLATION

for Preparation Click here



1. INSTALL CLEARANCE WARNING ECU ASSEMBLY



B110795E01

  1. Install the clearance warning ECU and power source control ECU with the 2 nuts.

  1. Connect the clearance warning ECU and power source control ECU connectors.



2. INSTALL TELEVISION CAMERA CONTROLLER


B110798

  1. Install the controller with the nut and bolt.

  1. Connect the 2 controller connectors.

  1. Connect the clearance warning ECU and power source control ECU connectors.



3. INSTALL GLOVE COMPARTMENT DOOR SUB-ASSEMBLY


B105648E04

  1. Attach the 2 clips and claw to install the glove compartment door.

  1. Connect the connector and clamp.

  1. Install the 4 screws.



4. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    C107050

  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the front passenger side knee airbag assembly with the 3 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B108847E02

  1. Connect the connector and clamp.

  1. Attach the 4 clips to install the under cover.



6. INSTALL INSTRUMENT SIDE PANEL LH


B105642E03

  1. Attach the 2 claws and 4 clips to install the side panel.



7. INSTALL FRONT DOOR OPENING TRIM COVER LH

  1. Attach the 3 claws to install the trim cover.

  1. Pull out the folded lip of the weatherstrip.



8. INSTALL FRONT DOOR SCUFF PLATE LH


B111646E01

  1. Attach the 5 claws to install the scuff plate.

  1. Pull out the folded lip of the weatherstrip.



9. INSTALL INSTRUMENT PANEL FINISH PANEL END LH


B105636E10

  1. Attach the 4 clips and 3 claws to install the finish panel end.

  1. Install the screw.



10. INSTALL CONSOLE UPPER PANEL ASSEMBLY


B111908E02

  1. Connect the connector.

  1. Attach the 9 clips to install the ash receptacle.



    B110192

  1. Install the shift lever knob and twist it in the direction indicated by the arrow.



11. INSTALL FRONT CONSOLE UPPER PANEL GARNISH

  1. Attach the claws to install the garnish.



12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


13. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.