ULTRASONIC SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 ULTRASONIC SENSOR


B110248

  1. Install the sensor to the rear bumper.

  1. Install the sensor retainer as shown in the illustration.

  1. Connect the sensor connector.



2. INSTALL NO. 2 ULTRASONIC SENSOR


B109678

  1. Install the sensor to the rear bumper.

  1. Install the sensor retainer as shown in the illustration.

  1. Connect the sensor connector.



3. INSTALL REAR BUMPER COVER

  1. w/ Clearance sonar system:
    Connect the 4 ultrasonic sensor connectors.



    B110493E01

  1. Attach the 7 claws on the LH side.

  1. Attach the 7 claws on the RH side.



    B106156

  1. Install the bumper cover with the 4 clips and 6 screws.



4. INSTALL REAR BUMPER NO. 1 PLATE

  1. Install the 2 bumper plates.



5. INSTALL NO. 3 ULTRASONIC SENSOR


    B109679

  1. Install the sensor retainer to the front bumper.



    B109681

  1. Install the sensor as shown in the illustration.

  1. Connect the sensor connector.



6. INSTALL FRONT BUMPER COVER

  1. Connect the ultrasonic sensor connector.



    B107496E02

  1. Attach the 3 claws on the LH side.

  1. Attach the 3 claws on the RH side.



    B109982

  1. Install the bumper cover with the 2 clips, 6 screws and 5 bolts.



7. INSTALL FRONT FENDER LINER LH


    B106148

  1. Install the fender liner with the 2 clips.



8. INSTALL FRONT FENDER LINER RH

HINT:
Use the same procedures described for the LH side.



9. INSTALL ENGINE UNDER COVER


B107493

  1. Install the under cover with the 3 clips and 10 screws.



10. INSTALL COOL AIR INTAKE DUCT SEAL


B106147

  1. Install the duct seal with the 7 clips.



11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


12. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.