CIGARETTE LIGHTER ASSEMBLY > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH


B111912

  1. Using a clip remover, detach the claws and remove the garnish.

    HINT:
    Tape the clip remover tip before use.



3. REMOVE CONSOLE UPPER PANEL ASSEMBLY


B110191

  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



    B111908E01

  1. Using a screwdriver, detach the 9 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the ash receptacle and then disconnect the connector.



4. REMOVE CIGARETTE LIGHTER ASSEMBLY


    B109132

  1. Rotate the socket body in the direction indicated by the arrow mark, and remove the socket body from the cigarette lighter.



    B110246E01

  1. Rotate the ring nut in the direction indicated by the arrow mark, and remove the cigarette lighter from the console panel.