CENTER POWER OUTLET SOCKET > INSTALLATION



1. INSTALL POWER OUTLET SOCKET ASSEMBLY


B110252

  1. Align the protrusion on the backside of the socket with the groove of the cover. Then push the socket into the cover.

  1. Connect the connector.



2. INSTALL CONSOLE BOX SUB-ASSEMBLY


B108018

  1. Install the console box, as shown in the illustration.



3. INSTALL REAR CONSOLE ARMREST ASSEMBLY


B105665

  1. Install the armrest with the 4 screws.



4. INSTALL CONSOLE BOX


B106268

  1. Connect the connector.

  1. Install the console box with the 4 bolts and 2 screws.



5. INSTALL CONSOLE BOX REGISTER ASSEMBLY


B105635E01

  1. Using a screwdriver, detach the 4 clips and remove the register.

    HINT:
    Tape the screwdriver tip before use.



6. INSTALL CONSOLE BOX PLATE


B105638E10

  1. Connect the connector.

  1. Attach the 4 clips to install the console box.



7. INSTALL INSTRUMENT PANEL FINISH PANEL END LH


B105636E10

  1. Attach the 4 clips and 3 claws to install the finish panel end.

  1. Install the screw.



8. INSTALL INSTRUMENT PANEL FINISH PANEL END RH


B105637E08

  1. Attach the 3 clips and 3 claws to install the finish panel end.

  1. Install the screw.



9. INSTALL CONSOLE UPPER PANEL ASSEMBLY


B111908E02

  1. Connect the connector.

  1. Attach the 9 clips to install the ash receptacle.



    B110192

  1. Install the shift lever knob and twist it in the direction indicated by the arrow.



10. INSTALL FRONT CONSOLE UPPER PANEL GARNISH

  1. Attach the claws to install the garnish.



11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


12. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.