LOW PITCHED HORN > INSTALLATION

for Preparation Click here



1. INSTALL LOW PITCHED HORN ASSEMBLY


B109673

  1. Place the stay onto the baffle part of the radiator support upper, and then install the horn with the bolt.

    Torque:
    20 N*m{ 205 kgf*cm , 15 ft.*lbf }

    NOTICE:
    Do not overlap the horn and the protruding part of the radiator support.

  1. Connect the connector.



2. INSTALL FRONT BUMPER COVER

  1. Connect the ultrasonic sensor connector.



    B107496E02

  1. Attach the 3 claws on the LH side.

  1. Attach the 3 claws on the RH side.



    B109982

  1. Install the bumper cover with the 2 clips, 6 screws and 5 bolts.



3. INSTALL FRONT FENDER LINER LH


    B106148

  1. Install the fender liner with the 2 clips.



4. INSTALL FRONT FENDER LINER RH

HINT:
Use the same procedures described for the LH side.



5. INSTALL ENGINE UNDER COVER


B107493

  1. Install the under cover with the 3 clips and 10 screws.



6. INSTALL COOL AIR INTAKE DUCT SEAL


B106147

  1. Install the duct seal with the 7 clips.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


8. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.