AIR CONDITIONING AMPLIFIER > INSTALLATION

for Preparation Click here



1. INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY


    E107651
  1. Install the A/C amplifier with the screw and connect the connector.



2. INSTALL NO. 2 AIR DUCT


    E107650
  1. Install the air duct with the screw.



3. INSTALL GLOVE COMPARTMENT DOOR SUB-ASSEMBLY


B105648E04
  1. Attach the 2 clips and claw to install the glove compartment door.

  1. Connect the connector and clamp.

  1. Install the 4 screws.



4. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    C107050
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the front passenger side knee airbag assembly with the 3 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B108847E02
  1. Connect the connector and clamp.

  1. Attach the 4 clips to install the under cover.



6. INSTALL INSTRUMENT PANEL FINISH PANEL END RH


B105637E08
  1. Attach the 3 clips and 3 claws to install the finish panel end.

  1. Install the screw.



7. INSTALL CONSOLE UPPER PANEL ASSEMBLY


B111908E02
  1. Connect the connector.

  1. Attach the 9 clips to install the ash receptacle.



    B110192
  1. Install the shift lever knob and twist it in the direction indicated by the arrow.



8. REMOVE FRONT CONSOLE UPPER PANEL GARNISH
  1. Attach the claws to install the garnish.



9. INSTALL INSTRUMENT SIDE PANEL RH

HINT:
Use the same procedures described for the LH side.



10. INSTALL FRONT DOOR OPENING TRIM COVER RH

HINT:
Use the same procedures described for the LH side.



11. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.



12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


13. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.