SEAT BELT CONTROL ECU > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT


B109029

  1. Remove the floor mat.



3. REMOVE TOOL BOX


B109030

  1. Remove the tool box.



4. REMOVE REAR FLOOR FINISH PLATE


B107125E01

  1. Remove the 3 clips labeled A.

  1. Detach the 4 clips to remove the finish plate.



5. REMOVE LUGGAGE COMPARTMENT TRIM COVER FRONT


B081724

  1. Detach the hook.



    B110747

  1. Remove the rope hook.



    B107126E01

  1. Detach the 4 claws and remove the trim cover.



6. REMOVE LUGGAGE COMPARTMENT TRIM SIDE COVER INNER LH


B109034

  1. Using a clip remover, remove the 3 clips and trim cover.



7. REMOVE SEAT BELT CONTROL ECU


    B109363E01

  1. Remove the 3 nuts and disconnect the ECU.



    B111674E02

  1. Disconnect the connector.

  1. Remove the nut.

  1. Detach the claw and remove the ECU.