CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE COOL AIR INTAKE DUCT SEAL


    A110865E01

  1. Remove the 7 clips and intake duct seal.



3. REMOVE ENGINE ROOM SIDE COVER RH


    A110866E01

  1. Remove the nut, 2 clips and side cover.



4. REMOVE ENGINE ROOM SIDE COVER LH


    A110867E01

  1. Remove the 3 clips and side cover.



5. REMOVE V-BANK COVER

  1. Remove the 2 nuts and V-bank cover.



6. REMOVE NO. 1 AIR CLEANER INLET

  1. Remove the bolt and air cleaner inlet.



7. REMOVE INTAKE AIR CONNECTOR PIPE


    A105826

  1. Disconnect the air hose and No. 1 ventilation hose.

  1. Loosen the 2 hose clamps and remove the intake air connector.



8. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY RH


    A100722

  1. Disconnect the oil control valve connector.

  1. Remove the bolt and oil control valve.

  1. Remove the O-ring from the oil control valve.



9. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY LH


    A100721

  1. Disconnect the oil control valve connector.

  1. Remove the bolt and oil control valve.

  1. Remove the O-ring from the oil control valve.