ECM > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE COOL AIR INTAKE DUCT SEAL


    A110865E01

  1. Remove the 7 clips and intake duct seal.



3. REMOVE ENGINE ROOM SIDE COVER LH


    A110867E01

  1. Remove the 3 clips and side cover.



4. REMOVE ECM COVER


    A105290

  1. Remove the 3 bolts and ECM cover.

    NOTICE:
    1. Make sure there is no water n or around the ECM cover.
    2. Perform the inspection indoors to avoid rain.
    3. Prevent water from contacting the ECM's connectors and screw areas.



5. REMOVE ECM


    A110870E01

  1. Disconnect the wire harness.

    1. Using a screwdriver, disconnect the 2 connector holders.

    2. Disconnect the 5 ECM connectors.



    A105821

  1. Remove the 2 nuts and ECM from the ECM box.