MASS AIR FLOW METER > INSTALLATION

for Preparation Click here



1. INSTALL INTAKE AIR FLOW METER


    A107650

  1. Install a new O-ring to the MAF meter.

  1. Install the MAF meter with the 2 screws.

  1. Connect the MAF meter connector.



2. INSTALL V-BANK COVER

  1. Install the V-bank cover with the 2 nuts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



3. INSTALL ENGINE ROOM SIDE COVER RH


    A110866E01

  1. Install the side cover with the 2 clips and nut.



4. INSTALL COOL AIR INTAKE DUCT SEAL


    A110865E01

  1. Install the intake duct seal with the 7 clips.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.