ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the radiator cap and vent plug.



  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A110177E01



3. REMOVE COOL AIR INTAKE DUCT SEAL


    A110865E01

  1. Remove the 7 clips and intake duct seal.



4. REMOVE ENGINE ROOM SIDE COVER RH


    A110866E01

  1. Remove the nut, 2 clips and side cover.



5. REMOVE V-BANK COVER

  1. Remove the 2 nuts and V-bank cover.



6. REMOVE NO. 1 AIR CLEANER INLET

  1. Remove the bolt and air cleaner inlet.



7. REMOVE INTAKE AIR CONNECTOR PIPE


    A105826

  1. Disconnect the air hose and No. 1 ventilation hose.

  1. Loosen the 2 hose clamps and remove the intake air connector.



8. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    A105814

  1. Disconnect the sensor connector.

  1. Remove the sensor.

  1. Remove the gasket from the sensor.