CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR


    A106635

  1. Install the sensor with the bolt.

    Torque:
    6.5 N*m{ 66 kgf*cm , 57 in.*lbf }

  1. Connect the sensor connector.



2. INSTALL OIL FILTER ELEMENT SERVICE HOLE COVER


    A106639

  1. Install the service hole cover with the 6 screws.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.