INTEGRATION RELAY > INSTALLATION

for Preparation Click here



1. INSTALL INTEGRATION RELAY

  1. Connect the 3 connectors.

  1. Attach the integration relay to the engine room No. 2 junction block.

  1. Install the engine room No. 2 relay block cover.



2. REMOVE ENGINE ROOM SIDE COVER LH


A105934E01

  1. Install the side cover with the 3 clips.



3. REMOVE COOL AIR INTAKE DUCT SEAL


    A105932E01

  1. Install the intake duct seal with the 7 clips.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.