INTEGRATION RELAY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE COOL AIR INTAKE DUCT SEAL


A105932E01

  1. Remove the 7 clips and duct seal.



3. REMOVE ENGINE ROOM SIDE COVER LH


A105934E01

  1. Remove the 3 clips and side cover.



4. REMOVE INTEGRATION RELAY

  1. Remove the engine room No. 2 relay block cover.



    A105813

  1. Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room No. 2 junction block.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the 3 connectors.