OUTER REAR VIEW MIRROR > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  1. The procedures listed below are for the LH side.



1. INSTALL OUTER REAR VIEW MIRROR COVER


    E107995E01

  1. Attach the claw and 3 clips to install the mirror cover.



2. INSTALL OUTER MIRROR LIGHT ASSEMBLY


    E107994

  1. Install the mirror light.



3. INSTALL OUTER REAR VIEW MIRROR VISOR


    E107993

  1. Install the mirror visor with the 4 screws.



4. INSTALL OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH

  1. Connect the connectors.



    E108542E01

  1. Attach the 2 claws and clips to install the mirror.



5. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH


    E107990E01

  1. Install the mirror with the 3 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Attach the clip.

  1. Connect the connector.



6. INSTALL DOOR FRAME GARNISH LH


B106669E03

  1. Install the garnish with the 2 clips.



7. INSTALL FRONT DOOR TRIM COVER LH


B106674E02

  1. Install the screw.

  1. Attach the 6 clips to install the trim cover.



8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


B110182

  1. Connect the 2 cables to the inside handle as shown in the illustration.



    B110168E04

  1. Install the weatherstrip to the trim by attaching the 4 clips labeled A.

  1. Attach the 6 clips labeled B and 3 new clips labeled C to install the trim together with the weatherstrip.

  1. Install the 2 screws.



    B109742E02

  1. Connect the connector.

  1. Attach the 2 claws to install the trim lower cover.



9. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


B106665E05

  1. Attach the 3 claws to install the bezel plug.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


11. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.