INNER REAR VIEW MIRROR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE INNER REAR VIEW MIRROR COVER


B108683E01

  1. Pull the cover in the direction indicated by the arrow in the illustration. Then remove the cover.



3. REMOVE FRONT ROOFTOP GARNISH


B111634E01

  1. w/ Rain sensor:
    Remove the top garnish.

    1. Using a screwdriver, detach the 3 claws and 2 clips, and remove the top garnish.

      HINT:
      Tape the screwdriver tip before use.

  1. w/o Rain sensor:
    Remove the top garnish.

    1. Using a screwdriver, detach the 3 claws and 2 clips, and remove the top garnish.

      HINT:
      Tape the screwdriver tip before use.



4. REMOVE PERSONAL LIGHT ASSEMBLY


B111635E01

  1. Using a screwdriver, remove the 2 covers and 2 screws.

  1. Using a moulding remover, detach the 2 clips and 3 claws.

  1. Disconnect the connector and remove the personal light.



5. REMOVE INNER REAR VIEW MIRROR ASSEMBLY


    E109862

  1. Remove the screw.



    E107999

  1. Disconnect the connector and remove the mirror.