POWER SEAT SWITCH > REMOVAL

for Preparation Click here


HINT:
Use the same procedures for the LH and RH side.



1. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


B105917E01

  1. Using a screwdriver, detach the 2 claws and remove the front seat belt cover.

    HINT:
    Tape the screwdriver tip before use.



    B105918E01

  1. Apply protective tape around the seat belt anchor cover cap to the cushion shield.

  1. Using a screwdriver, detach the 2 claws and remove the seat belt anchor cover cap.

    HINT:
    Tape the screwdriver tip before use.

  1. Move the seat using the power seat switch knob so that the belt anchor bolt is revealed.



    B105919

  1. Remove the bolt and front seat outer belt anchor.



2. REMOVE RECLINING POWER SEAT SWITCH KNOB


B105922

  1. Using a screwdriver, detach the knob.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB


B105923

  1. Using a screwdriver, detach the knob.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY

  1. Disconnect the 2 rubber bands of the front seatback board from the front seat frame.



    B105925E01

  1. Remove the 5 screws.

  1. Detach the claw and remove the cushion shield assembly in the order indicated in the illustration.

  1. Disconnect the connector from the lumbar front power seat switch.



5. REMOVE FRONT POWER SEAT SWITCH


B101235

  1. Remove the 3 screws.

  1. Disconnect the connector and remove the switch.