DRIVE BELT > INSTALLATION

for Preparation Click here



1. INSTALL V-RIBBED BELT


    A107652E02

  1. Set the V-belt to everything except the No. 2 idler pulley, as shown in the illustration.

  1. Loosen the V-belt by turning the belt tensioner counterclockwise.

  1. Then set the V-belt to the idler pulley.



    A052038

  1. After a new belt has been installed, check that the mark is within the A range shown in the illustration.



2. INSTALL NO. 1 AIR CLEANER INLET

  1. Install the air cleaner inlet with the bolt.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



3. INSTALL COOL AIR INTAKE DUCT SEAL


    A110865E01

  1. Install the intake duct seal with the 7 clips.