FRONT POWER SEAT LUMBAR SWITCH > INSPECTION

for Preparation Click here

1. Measure the resistance between the terminals when the switch is operated.
   

   Standard resistance:

   Tester Connection	Switch Condition	Specified Condition
   1 (E2) - 5 (R)	HOLD	Below 1 Ω
   2 (B) - 3 (H)	HOLD	Below 1 Ω
   1 (E2) - 5 (R)	OFF	Below 1 Ω
   3 (H) - 4 (E)	OFF	Below 1 Ω
   2 (B) - 5 (R)	RELEASE	Below 1 Ω
   3 (H) - 4 (E)	RELEASE	Below 1 Ω

   If the result is not as specified, replace the switch.
   

Standard resistance:

Tester Connection	Switch Condition	Specified Condition
4 (E2) - 3 (R)	HOLD	Below 1 Ω
2 (B) - 5 (H)	HOLD	Below 1 Ω
4 (E2) - 3 (R)	OFF	Below 1 Ω
5 (H) - 1 (E)	OFF	Below 1 Ω
2 (B) - 3 (R)	RELEASE	Below 1 Ω
5 (H) - 1 (E)	RELEASE	Below 1 Ω