MULTIPLEX TILT AND TELESCOPIC ECU > INSTALLATION

for Preparation Click here



1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU


    C105553

  1. Using a socket wrench (+), install the multiplex tilt and telescopic ECU with the 2 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }

  1. Connect the connector to the multiplex tilt and telescopic ECU.

    NOTICE:
    1. The connectors on both ends of the wire harness between the telescopic motor and ECU are the same shape.
    2. When installing them, connect the connectors of the same color.



2. INSTALL STEERING LOCK ACTUATOR ASSEMBLY

  1. Temporarily install the steering lock actuator assembly with 2 new tapered-head bolts.



    C105552

  1. Tighten the 2 tapered-head bolts until the bolt heads break off.



3. INSTALL STEERING COLUMN ASSEMBLY (for 3GR-FSE)

HINT:
Refer to the instructions for installation of the steering column assembly (3GR-FSE) (Click here).



4. INSTALL STEERING COLUMN ASSEMBLY (for 3GR-FE)

HINT:
Refer to the instructions for installation of the steering column assembly (3GR-FE) (Click here).



5. INSTALL STEERING COLUMN ASSEMBLY (for 3UZ-FE)

HINT:
Refer to the instructions for installation of the steering column assembly (3UZ-FE) (Click here).