MULTIPLEX TILT AND TELESCOPIC ECU > REMOVAL

for Preparation Click here



1. REMOVE STEERING COLUMN ASSEMBLY (for 3GR-FSE)

HINT:
Refer to the instructions for removal of the steering column assembly (3GR-FSE) (Click here).



2. REMOVE STEERING COLUMN ASSEMBLY (for 3GR-FE)

HINT:
Refer to the instructions for removal of the steering column assembly (3GR-FE) (Click here).



3. REMOVE STEERING COLUMN ASSEMBLY (for 3UZ-FE)

HINT:
Refer to the instructions for removal of the steering column assembly (3UZ-FE) (Click here).



4. REMOVE STEERING LOCK ACTUATOR ASSEMBLY

  1. Using a center punch, mark the center of the 2 tapered-head bolts.

  1. Using a 3 to 4 mm (0.12 to 0.16 in.) drill, drill a hole in the 2 bolts.



    C105551E01

  1. Using a screw extractor, remove the 2 bolts and steering lock actuator assembly from the steering column assembly.



5. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU


    C105553

  1. Disconnect the connector form the multiplex tilt and telescopic ECU.

  1. Using a screwdriver, remove the 2 screws and multiplex tilt and telescopic ECU.