SEAT BELT WARNING SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here

Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
The combination meter is based on the premise that the supplemental restraint system (SRS) is operating normally. Check the SRS first before troubleshooting the seat belt warning system.

Seat belt warning system
Symptom	Suspected area	See page
Seat belt warning light for driver seat does not operate	Center airbag sensor assembly	Click here
	Combination meter assembly	Click here
	Front seat inner belt assembly (driver side)	Click here
	Instrument cluster finish panel sub-assembly	Click here
	Wire harness	Click here
Seat belt warning light for passenger seat does not operate	Front seat inner belt assembly (passenger side)	Click here
	Separate type front seat cushion pad (occupant detection sensor)	Click here
	Combination meter assembly	Click here
	Center airbag sensor assembly	Click here
	Multi-display	Click here
	Wire harness	Click here
Seat belt warning buzzer does not sound* (Seat belt warning lights for driver and passenger seat operate normally)	Combination meter assembly	Click here

*: Europe, Australia and New Zealand only