ACCELERATOR PEDAL > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ACCELERATOR PEDAL


    A103811E08

  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Push the intelligent tester main switch ON.

  1. Select the following menus: Powertrain / Engine / Data List / Accelerator Pedal Position No. 1 and Accelerator Pedal Position No. 2.

  1. When depressing or releasing the accelerator pedal, check that the values of the accelerator pedal position No. 1 and accelerator pedal position No. 2 are within the specification.

    Accelerator Pedal Position No. 1 standard voltage:

    Condition
    		Specified Condition
    Accelerator pedal is released
    		0.5 to 1.1 V
    Accelerator pedal is depressed
    		2.6 to 4.5 V


    Accelerator Pedal Position No. 2 standard voltage:

    Condition
    		Specified Condition
    Accelerator pedal is released
    		1.2 to 2.0 V
    Accelerator pedal is depressed
    		3.4 to 5.0 V

    HINT:
    If the result is not as specified, check the accelerator pedal, wire harness or ECM.