FUEL PRESSURE PULSATION DAMPER > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    B002076E01

  1. Install 2 new gaskets, the fuel main tube and pulsation damper to the fuel pump.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf } for use without SST33 N*m{ 337 kgf*cm , 24 ft.*lbf } for use with SST



2. INSTALL V-BANK COVER

  1. Install the cover with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. CHECK FOR FUEL LEAKS

  1. Check for fuel leaks (Click here).



5. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.