REAR SUNSHADE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Read the Data List according to the display on the tester.

    Integration control and panel assembly 
    Item
    		Measurement Item / Range (Display)
    		Normal Condition
    		Diagnostic Note
    Rear Sunshade Switch
    		Rear sunshade switch (front switch) / ON or OFF
    		ON: Rear sunshade switch is pressed
    OFF: Rear sunshade switch is not pressed
    		-


PERFORM ACTIVE TEST

HINT:
Performing the intelligent tester's Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Perform the Active Test according to the display on the tester.

    Multiplex network rear ECU 
    Item
    		Test Details
    		Diagnostic Note
    Reverse signal control
    		Reverse Signal output control / Hi (ON) or Lo (OFF)
    		-