SLIDING ROOF HOUSING > DISASSEMBLY

for Preparation Click here



1. REMOVE SLIDING ROOF MOUNTING BRACKET LH

  1. Remove the 3 bolts and bracket from the roof housing.



2. REMOVE SLIDING ROOF MOUNTING BRACKET RH

HINT:
Use the same procedures described for the LH side.



3. REMOVE SLIDING ROOF DRIVE GEAR ASSEMBLY

  1. Detach the bracket's claw and remove the bracket.

  1. Remove the 2 bolts and drive gear.



4. REMOVE SUNSHADE TRIM ASSEMBLY

  1. Remove the 2 sliding roof panel stoppers and trim.



5. REMOVE SLIDING ROOF DRIVE CABLE ASSEMBLY


  1. Only when replacing the sliding roof drive cable:

    1. Remove the 2 screws and 2 sliding roof side stoppers.

    2. Remove the screw and sliding roof piece LH.

    3. Remove the screw and sliding roof piece RH.



      4. B108854

    4. Using a screwdriver, detach the 2 claws. Then slide the drip channel rearward to remove it.

      HINT:
      Tape the screwdriver tip before use.



      5. B108855

    5. Using a screwdriver, slide the drive cable in the direction indicated by the arrow in the illustration to remove it.

      HINT:
      Tape the screwdriver tip before use.



6. REMOVE ROOF WIND DEFLECTOR PANEL ASSEMBLY


B108859

  1. Using a screwdriver, detach the 2 claws. Then remove the wind deflector panel.

    HINT:
    Tape the screwdriver tip before use.