SLIDING ROOF HOUSING > REASSEMBLY

for Preparation Click here



1. INSTALL ROOF WIND DEFLECTOR PANEL ASSEMBLY

  1. Attach the 2 claws to install the wind deflector panel.



2. INSTALL SLIDING ROOF DRIVE CABLE ASSEMBLY


B108856

  1. Using a screwdriver, slide the drive cable in the direction indicated by the arrow in the illustration to install it.

    HINT:
    Tape the screwdriver tip before use.

  1. Attach the 2 claws to install the drip channel.

  1. Install the sliding roof piece LH and RH with the 2 screws.

  1. Install the 2 sliding roof side stoppers with the 2 screws.



3. ADJUST SLIDING ROOF DRIVE CABLE ASSEMBLY


B108857E01

  1. Using a screwdriver, align the matchmarks by sliding the drive cable in the direction indicated by the arrow in the illustration.

    HINT:
    Tape the screwdriver tip before use.



4. INSTALL SUNSHADE TRIM ASSEMBLY


5. INSTALL SLIDING ROOF DRIVE GEAR ASSEMBLY

  1. Install the drive gear with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Attach the bracket's claw to install the bracket.



6. INSTALL SLIDING ROOF MOUNTING BRACKET LH

  1. Install the bracket with the 3 bolts.



7. INSTALL SLIDING ROOF MOUNTING BRACKET RH

HINT:
Use the same procedures described for the LH side.